logo

3014 Side View 60LED/meter CRI>80

3014-side-view-12v-60led-cri80-flexible-LED-strip-ribbon-13014-side-view-24v-60led-cri80-flexible-LED-strip-ribbon-1
12VDC & 24VDC 4014 side view 60LED/meter  flexible LED strip

Features

* Apply high brightness 4014 side view SMD LED, 

* Standard color temperature available:  2900K-3200K(IN), 4000K-4200K(DN), 6000K-6500K(WN)

* Working current per LED can be designed as 10mA to 30mA according to detail application request

* 3M self-adhesive tape on the back


  • PCB Width 8mm 60LED/meter 2216 flexible LED strip CRI 90-95 & CRI 95-97

    Dimension

    3014-side-view-12v-60led-cri80-flexible-LED-strip-ribbon-dimension
    12VDC
    3014-side-view-24v-60led-cri80-flexible-LED-strip-ribbon-dimensino24VDC

    Parameter @25mA per LED 12VDC & 24VDC 3014 side view 60LED/meter flexible LED strip 

    CRI>80 LED strip light @25mA per LED 

    3014-side-view-12v-60led-cri80-flexible-LED-strip-ribbon-parameter12VDC

    3014-side-view-24v-60led-cri80-flexible-LED-strip-ribbon-parameter

    24VDC

    (The working current can be designed as 10mA to 30mA per LED, if you have customized LED strip request, pls contact us sales@coolightled.com )

Light Distribution Curve(cd)

3014-side-view-12v-120led-cri80-flexible-LED-strip-ribbon-light

3014 side view 60LED/meter 12VDC & 24VDC flexible LED strip ribbon package info

Coolight led strip lighting package

3014-side-view-cri80-flexible-LED-strip-ribbon-package

Caution

* Installation of LED modules (with power supplies) needs to be made with regard to all applicable and
safety standards. Only qualified personnel should be allowed to perform installations.
* Assembly must not damage or destroy conducting paths on the circuit board.
* Observe correct polarity!
* Please ensure that the power supply is of adequate power to operate the total load.
* When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation at soldering points between module and the mounting surface.
* The maximum run length from any power feed should be limited to 5000 mm.
* Soldering of wires with the module mounted on a heat sink: Pre-tin solder pads and wires and solder for max 3 s at 350 °C. Allow solder points to completely cool down before the next soldering.Prevent shear- or peel forces.
* The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle.
The mounting substrate must have sufficient structural integrity. Take care to completely remove the protective film. Once the module is appropriately positioned, press on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes).
* The minimum bending radius is 20 mm.
* When installing in environments with large variations in temperature and operating length of more than 2 m, the use of metallic mounting surfaces is necessary. Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.