logo

3014 240LED/meter Mixed-color CRI>80

Part No.: CL-WINF241200-240T7-W (24V DC)

3014 240ledmeter cw-ww mixed color flexilbe led strip

3014 24V 240led cw-ww mixed color flexible LED strip

Features

* Apply single color 3014 SMD LED
* Wide beam angle,120degree
* 3M self-adhesive tape on the back
* Can be cut every 12LEDs along the cut-mark
* This LED strip is dimmable, you can use a dimmer based on PWM technology to dim it.

Application

* Architectural decorative lighting
* Signage letters back-lighting
* Arch edge lighting
* Home or Club mood lighting
* Staircase accent lighting
* Car decoration

Dimension

3014 240ledmeter mixed color flexible led strip ribbon dimension

Parameter

3014 240ledmeter mixed color flex led strip ribbon parameter02

3014 240ledmeter mixed color flexible led ribbon parameter1

Light Distribution Curve(cd)

3014 240led mix-color led flex strip light

Lux Test Diagram(Lux)

3014 240ledmeter flex led strip ribbon lux

3014 24VDC 240LED/meter Mixed-color CCT Color Temperature Tunable Flexible LED Strip Package Info

Coolight led strip lighting package

3014 240led double color tunable flex led strip package

Caution

* Installation of LED modules (with power supplies) needs to be made with regard to all applicable and
safety standards. Only qualified personnel should be allowed to perform installations.
* Assembly must not damage or destroy conducting paths on the circuit board.
* Observe correct polarity!
* Please ensure that the power supply is of adequate power to operate the total load.
* When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation at soldering points between module and the mounting surface.
* The maximum run length from any power feed should be limited to 5000 mm.
* Soldering of wires with the module mounted on a heat sink: Pre-tin solder pads and wires and solder for max 3 s at 350 °C. Allow solder points to completely cool down before the next soldering.Prevent shear- or peel forces.
* The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle.
The mounting substrate must have sufficient structural integrity. Take care to completely remove the protective film. Once the module is appropriately positioned, press on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes).
* The minimum bending radius is 20 mm.
* When installing in environments with large variations in temperature and operating length of more than 2 m, the use of metallic mounting surfaces is necessary. Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.

3014 24VDC 240LED/meter Mixed-color CCT Color Temperature Tunable Flexible LED Strip Ribbon

3014 24V 240led cw-ww mixed color flexible LED strip1

When only Warm-white color LEDs turn on

3014 24V 240led cw-ww mixed color flexible LED strip4

When only Cool-white color LEDs turn on

3014 24V 240led cw-ww mixed color flexible LED strip3

When both Warm-white color and Cool-white LEDs turn on

3014 24V 240led cw-ww mixed color flexible LED strip2

 

Use together with 2channel LED controller, you can get a lot of mixed color temperature between the Warm-white color and Cool-white color LED used.



About Coolight LED lighting