logo

2835 120LED/meter CRI>80 & CRI 90-95 & CRI 95-97

2835 120led 24v flexible led strip

24VDC 120LED/meter 2835 flexible LED strip

Features

* Apply 2835 CRI>80 & CRI 90-95 R9>50 & CRI 95-97 R9>90 SMD LED 

* Standard color temperature available: 3000K(IN), 4000K(DN), 6000K(WN)

* Working current per LED can be designed as 10mA to 60mA according to detail application request

* 3M self-adhesive tape on the back


  • PCB Width 10mm 120LED/meter 2835 flexible LED strip CRI>80 & CRI90-95 & CRI 95-97

    Dimension

    2835 120led flexible led strip
    Parameter @40mA per LED 24VDC 120LED/meter 2835 flexible LED strip 

    CRI>80 LED strip light @40mA per LED

    2835-24v-120led-cri80-flexible-led-strip-ribbon-parameter

    CRI 95-97 R9>90 LED strip light @40mA per LED

    2835-24v-120led-cri95-97-flexible-led-strip-ribbon-parameter

     

    (The working current can be designed as 10mA to 60mA per LED, if you have customized LED strip request, pls contact us sales@coolightled.com )

 

Light Distribution Curve(cd)

2835 120led 24v flex led strip light

Lux Test Diagram(Lux)

2835 120led 24v LED strip ribbon lux

2835 120LED/meter Flex LED Strip Ribbon Package 

Coolight led strip lighting package

 

2835 24v 120led flex strip package

Caution

* Installation of LED modules (with power supplies) needs to be made with regard to all applicable and
safety standards. Only qualified personnel should be allowed to perform installations.
* Assembly must not damage or destroy conducting paths on the circuit board.
* Observe correct polarity!
* Please ensure that the power supply is of adequate power to operate the total load.
* When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation at soldering points between module and the mounting surface.
* The maximum run length from any power feed should be limited to 5000 mm.
* Soldering of wires with the module mounted on a heat sink: Pre-tin solder pads and wires and solder for max 3 s at 350 °C. Allow solder points to completely cool down before the next soldering.Prevent shear- or peel forces.
* The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle.
The mounting substrate must have sufficient structural integrity. Take care to completely remove the protective film. Once the module is appropriately positioned, press on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes).
* The minimum bending radius is 20 mm.
* When installing in environments with large variations in temperature and operating length of more than 2 m, the use of metallic mounting surfaces is necessary. Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.