logo

2216 240LED/meter Mixed-color CRI 90-95 & CRI 95-97

240T16-10mm-24v-mixed-color-led-strip-ribbon-photo

24VDC Mixed-color 240LED/meter 2216 flexible LED strip

Features

* Apply 2216 CRI 90-95 & CRI 95-97 SMD LED, R9>50 at CRI 90-95, and R9>90 at CRI 95-97

* Standard color temperature available: 2250K-2475K(SN), 2700K-2830K(KN), 2830K-3040K(IN), 3900K-4258K(DN), 6000K-7034K(WN)

* Working current per LED can be designed as 10mA to 60mA according to detail application request

* 3M self-adhesive tape on the back


  • PCB Width 10mm Mixed-color 240LED/meter 2216 flexible LED strip CRI 90-95 & CRI 95-97

    Dimension

    240T16-10mm-24v-mixed-color-led-strip-ribbon- dimension

    Parameter @20mA per LED 24VDC Mixed-color 240LED/meter 2216 flexible LED strip 

    CRI 90-95 R9>50 LED strip light @20mA per LED 

    240T16-mixed-color-10mm-24v-20ma-cri90-95-led-strip-ribbon-parameter

    CRI 95-97 R9>90 LED strip light @20mA per LED 

    240T16-mixed-color-10mm-24v-20ma-cri95-97-led-strip-ribbon-parameter

    (The working current can be designed as 10mA to 60mA per LED, if you have customized LED strip request, pls contact us sales@coolightled.com )


Light Distribution Curve(cd)

2216 24v mixed color 240led flex led strip ribbon light

Lux Test Diagram(Lux)

2216 240led mixed color flexile led strip ribbon 24V lux

2216 24VDC 240LED/meter High CRI 90-95 Mixed Color Flexible LED Strip Package Info

Coolight led strip lighting package

2216 240led 24v flexible led ribbon strip package

Caution

* Installation of LED modules (with power supplies) needs to be made with regard to all applicable and
safety standards. Only qualified personnel should be allowed to perform installations.
* Assembly must not damage or destroy conducting paths on the circuit board.
* Observe correct polarity!
* Please ensure that the power supply is of adequate power to operate the total load.
* When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation at soldering points between module and the mounting surface.
* The maximum run length from any power feed should be limited to 5000 mm.
* Soldering of wires with the module mounted on a heat sink: Pre-tin solder pads and wires and solder for max 3 s at 350 °C. Allow solder points to completely cool down before the next soldering.Prevent shear- or peel forces.
* The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle.
The mounting substrate must have sufficient structural integrity. Take care to completely remove the protective film. Once the module is appropriately positioned, press on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes).
* The minimum bending radius is 20 mm.
* When installing in environments with large variations in temperature and operating length of more than 2 m, the use of metallic mounting surfaces is necessary. Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.